# Will this power supply fit my LiPO charger? [closed]

I just got my brand new LiPO battery charger. It is require 12 volt pover supply. I saw people are using car battery, pc power supply to this charger 12 V. but i'm not sure about current it is require.

Here is spec:

Operating voltage range: 10.0~18.0Volt
Circuit power: max.50W for charging, max.5W for discharging
Charge current range: 0.1~5.0A
Discharge current range: 0.1~1.0A
Current drain for balancing Li-po: 300mAh/cell
NiCd/ NiMH battery cell count: 1~15cells
Lithium battery cell count: 1~6Series
Pb battery voltage: 2 to 20V
Dimension: 135×100×40mm


Will it be ok if i use for power supply plug in transformer which outputs 12 VDC, 800mA?

Dont wanna damage any of them.

-
To get close to the performance of the charger, you'll need a 5 A power supply. The calculation is simple P=V*I. Here P=50 W and I've used V=12 V and added a bit of safety margin. –  AndrejaKo Jun 18 '12 at 15:03
Consumer electronics support is off topic. I realize you are working hard to find a power supply for your unit you purchased but there is no design here. The focus of this is picking a cheap power supply. –  Kortuk Jun 21 '12 at 22:48

## closed as off topic by Kortuk♦Jun 21 '12 at 22:47

Questions on Electrical Engineering Stack Exchange are expected to relate to electronics design within the scope defined by the community. Consider editing the question or leaving comments for improvement if you believe the question can be reworded to fit within the scope. Read more about reopening questions here.If this question can be reworded to fit the rules in the help center, please edit the question.

Your plugin transformer outputs 800mA, your charger has 50W output max at 12V.

50W / 12V = 4.17A

Transformer you have is too weak for this. PC PSUs have output somewhere in range of 10A on 12V rail, that's why they can be used.

-
Will power supply (Transformer) burn if i use them together? –  Pol Jun 18 '12 at 15:19
it could burn, it all depends on a design of charger. –  miceuz Jun 18 '12 at 15:25
@Pol: take no chances and look for a PC PSU. Virtually any PSU will do the job, so you will be able to get one for free if you look in the right places. There are also a lot of tutorials on the web how to run a PSU without a mainboard attached. –  0x6d64 Jun 18 '12 at 15:32
What about notebook power supply? Is it to powerful for this charger? It shows 10.0~18.0Volt operating voltage range. I thing notebook charger would do the job. How go think? –  Pol Jun 18 '12 at 15:56
it depends on the charger, if it traks available power source, it might work with less performance, otherwise, it will melt your power supply. –  miceuz Jun 18 '12 at 16:11