Tell me more ×
Electrical Engineering Stack Exchange is a question and answer site for electronics and electrical engineering professionals, students, and enthusiasts. It's 100% free, no registration required.

I am considering connecting my Arduino UNO and Sainsmrt Sensor shield V4 to this TFT LCD . Are they compatible? If they are, how am i supposed to wire them up?

share|improve this question
8  
0% accept rate = no answer – stevenvh Jul 20 '12 at 5:16
3  
You must have seen Stevens comments by now, plus various requests for extra information about your problem(s). if so I don't quite understand why you would not supply the extra information or accept an answer. I don't like to say this, but it is beginning to look pretty impolite on your part, and does not help you or the site much. I think you would get a lot more help if you make a little more effort. – Oli Glaser Jul 20 '12 at 11:54
5  
13 questions, none accepted, and he's been back here two hours after Steven's comment. I'm with Steven on this one and refuse to help. – Olin Lathrop Jul 20 '12 at 12:12
@OlinLathrop: I didn't know how to accept an answer until I saw Steven's instruction. Sorry for my ignorance. – user10768 Jul 21 '12 at 2:26

1 Answer

up vote 1 down vote accepted

It has an SPI interface so you can certainly get your Arduino to talk with it. The link you provide doesn't reveal a datasheet (or I am overlooking it). You'll need to locate the datasheet to figure out exactly how to communicate.

share|improve this answer
I couldn't find the datasheet or the type of controller inside the LCD module either. Even if the O.P can make wiring work, I wonder how will he figure out the registers inside the LCD module? At the same time, there's a testimonial on the product page saying that somebody made it work. – Nick Alexeev Jul 21 '12 at 0:39

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.