Take the 2-minute tour ×
Electrical Engineering Stack Exchange is a question and answer site for electronics and electrical engineering professionals, students, and enthusiasts. It's 100% free, no registration required.

Could somebody please tell me where to find wire in the NI Multisim to connect logical gates to the VCC? I cannot find it.

share|improve this question
add comment

2 Answers

NI Multisim does not offer a separate wire tool. It is available as contextual tool and appears automatically. To wire two components click at source component terminal (say, an IC pin). This will create(start) a wire from there. Now move the mouse pointer and click on the target component terminal to establish a wire connection between the two components.

Also double clicking anywhere on the circuit workspace creates(starts) a wire and you can terminate it by double clicking again at the target location.

share|improve this answer
add comment

Double clicking anywhere creates a wire in multisim. You should also be able to click any endpoint to create a wire.

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.