I want to replace a physical N.O. switch with a microcontroller controlled transistor. The MCU is a ~3.3v MSP430. Since this is high side, I know I need a PNP transistor, and since the voltages are ...
The symbol below is for the component TL32P0 (TINY SWITCH ON - MON), included in EAGLE 6.5. In this symbol, which pin is normally-closed (NC)? 1 or 3? Or is the symbol not a typical one, i.e. not ...
I'm trying to understand the following circuit diagram: Specifically, the four triangles within the L293D component. So I understand there are two transistors in there, connected in series from 24v ...
i have some schematic from TINA pro, pspice, orcad and the lite. Is there a way to automatically convert it into a both breadboard and PCB layout. This is a bright idea since it will save time. What ...
What are the recommended placement and routing techniques for the following RC low pass filter circuit: I made an initial placement and routing that's shown below: Actually it's randomly placed ...
Possible Duplicate: Good Tools for Drawing Schematics I'm looking for a schematic editor/capture tool to use in the very initial steps of a digital design. This is, as a block diagram ...