I am working with hall effect sensor, which sends 10.75V on output wire when sensor fully active (the sensor is used in clutch pedal switch to tell the vehicle when clutch pedal is pressed or not). I ...
I'm building a battery powered device and need a few hall effect switches (uni- or omnipolar and non-latching) to count rotations, but I have no idea which manufacturers have a reputation for ...
On pg. 18 Figure 5 of this data sheet you will see a pulse train that allows for programming the sensitivity of the A1362 Hall-Effect sensor. So far I have tried to manually apply required voltage ...
I'm a mechanical engineer at uni who has some basic experience in electronics and programming. I'm building a system for my rowing boat to help me with my training. This will give me feedback on a ...
I drive all Manual Transmission vehicles, and after a long battle of wills with my girlfriend, she has conceded that she would learn if there was a display that showed what gear was selected, thinking ...
I'm dealing with a small automation project, a rack and pinion system controlled by an Arduino card with two limit switches to ensure that the rack moves within the boundaries. I have been trying both ...
I'm trying to make an onboard system for my bike using an Arduino or maybe the Lilypad boards. I think I should use a Hall effect sensor, but any alternative is good as well. I want to output my ...