I have an Arduino connected to a linux box (a Raspberry Pi). I'm reading an analog pin and writing it out with Serial.println() together with the value of ...
So I have a piece of hardware I'm reverse engineering. I believe I've found a UART on the board. I have an FPGA connected to it that just does: ...
The MSP-EXP430G2 LaunchPad Experimenter Board User's Guide (Rev. C) in chapter 3.2 states: The LaunchPad includes a pre-programmed MSP430G2553 device [...] Press button P1.3 to switch the ...
I am new to Processing and attempting to write code to communicate with my Arduino - on a linux platform. When I run the following code: println(Serial.list()); ...
I like to program my Arduino using Eclipse. However, I still need the Arduino IDE to use the Serial port monitor. This is very inconvenient and breaks my work flow I tried to use RXTX but this would ...
I am facing a weird problem with my stepper motor when I am trying to control it with my linux computer. As soon as the serial port is opened from my code to spin the stepper motor, my command ...