Important to inductors, transformers, generators, motors, magnetic fields, inductive heating, magnetic storage, permanent magnets

learn more… | top users | synonyms

2
votes
2answers
81 views

Back EMF and opposing current of a super conductor?

A 5 meter long super conductor carries 100 Amps, and it passes through a 1 Tesla magnetic field at 0.010 seconds, Is EMF = - (BL) / (t)? And since the resistance of the super conducting wire is zero, ...
4
votes
1answer
196 views

Magnetic field strength and bldc rotor

As a background to this project, I have taken an off the shelf bldc stator and incorporated it into a small pump, and then built my own rotor using discrete neodymium magnets. At first, everything ...
0
votes
1answer
57 views

How to design a magnetic vibrator?

I plan to create a magnetic vibrator to shake a small container. What I plan is to buy Two "Magnet Wire 14 AWG Gauge Enameled Copper 1.5lb 118ft 200C Magnetic Coil Winding" a custom made container ...
0
votes
1answer
157 views

How to implement a radial encoder with a diametrically magnetized magnet using a hall-effect sensor?

I want to implement a rotary encoder that doesn't use optical sensing or physical contacts. I found the following solution using a diametrically magnetized magnet on the shaft, and a dual axis hall ...
0
votes
1answer
145 views

Electromagnet duty cycle

I have a project where I would like to use an electromagnet to lift an item for a longer period of time. I was looking at a magnet like this one: ...
4
votes
0answers
100 views

Simulating a magnetic field in Spice

I am trying to simulate a circuit that involves pickup coils in Spice. How would one simulate the magnetic fields that the pickup coils can sense? Additionally, how would one get a frequency response ...
2
votes
0answers
270 views

How to route Gigabit Ethernet, remote PHY or remote RJ45 connector?

I need to design a 10/100/1000 BASE-T “backplane” board that contains multiple PHY outputs from Ethernet controller chips. On the board ,the LAN specifications are very strict in regard to how the ...
1
vote
0answers
86 views

Ground plane and magnets

I am making a wheel encoder out of a Hall Effect sensor with magnets in a concentric circle on the wheel. The Hall effect sensor is on a 2-layer 9x5mm pcb. I usually fill in the layers by drawing a ...
0
votes
0answers
883 views

What sensors are commonly used for vehicle detection?

I want to make a vehicle detection prototype. I find there are multiple choices of sensors that can be used to detect a vehicle, such as acoustic, ultrasonic, infrared, magnetic inductive sensor. I ...
0
votes
0answers
95 views

Two RJ45s one PHY

Is it possible connecting two RJ45s to a one port ethernet magnetics? If yes, Does it require just turns ratio adjustment or other issues have to be taken into account? Thanks!