A variation on the Arduino platform.

learn more… | top users | synonyms

0
votes
1answer
86 views

MCP23017 not causing interrupts using a normally open switch on power up

I'm working on a project where I am using two 4x4 button pads. I would need to use two MCP23017 for input interrupts to support the 32 buttons. I am using a Netduino and I'm coming across an issue ...
1
vote
0answers
97 views

PWM only works after touched with oscillicope probe

I am using two PWM outputs from a Netduino 2 to control two servos. One of the PWM pins works perfectly fine but the other doesn't work until I have touched it with an oscope probe. The probe doesn't ...
1
vote
0answers
92 views

Debug Netduino without .NET Micro Framework

I have a Netduino, but I am programming it using the GNU ARM toolchain in Eclipse and VisualGDB so the .NET Micro Framework (NETMF) firmware has been removed. Is there a way I can set it up for ...
0
votes
0answers
8 views

Xamarin Studio not recognising Netduino libraries

I've followed through the Netduino, Mono, and Monkey Robotics software configuration for the .Net Micro Framework and Netduino but run into the same errors every time: Micro framework 4.3 is not ...
0
votes
0answers
48 views

Netduino Plus 2 using InterruptPort to detect limit switches

I'm using a Netduino Plus 2 to control myCNC. I would like to add E-Stop and Limit Switch detection. Experimenting with E-Stop changes detected on Pins.GPIO_PIN_D11. Can I use Netduino's 3.3/5v as ...