0
votes
0answers
12 views

NOT consistent Euler Paths in logic diagram. What now?

i'm working with non-series-parallel arrangements, something like this: as you can see, the euler paths in pull-up and pull-down are differents. for example, in pull-up we have "abcde" and in ...
2
votes
1answer
99 views

How to route to a hidden pin in Altium

I'm using Altium Designer 14.2.3 and I have a connector on which are always two pins connected to each other. In my schematic library I have configured the Pins to be hidden and connected to the ...
3
votes
1answer
344 views

Power Plane and Decoupling Capacitors Routing

Forgive me for my simplicity. I'm just a hobbyist and not an engineer by trade. I am trying to make my first 4 layer PCB in Eagle and I have a question I cannot find the answer to regarding power ...
4
votes
1answer
1k views

How to connect ground planes together

What is the best way to connect ground planes together ? I know that ground planes are connected together at multiple locations in order to keep a low impedance GND across the whole board and provide ...
17
votes
9answers
4k views

Do you layout in mil or mm?

I have been using 10 mil trace with 10 mil spacing. The PCB vendors quote that they like traces down to 7 mil. But then I ran across a PDF showing how to fan out a QFP to get all the signals ...