Tagged Questions
2
votes
1answer
50 views
Eagle configure autorouter to solder components (except vias) only on bottom layer of double sided PCB
In double sided PCBs it is difficult to solder through hole components like IC bases, headers, etc. in the top layer. Normally the Eagle autorouter places the solder pads on both sides. That is, in a ...
5
votes
2answers
599 views
Eliminating Thermal Isolation Pads in Eagle
When creating a ground plane in Eagle, Eagle automatically creates a thermal isolation for the pad.
My first question is, does this isolation limit the current compared to a pad that is ...
2
votes
3answers
1k views
Eagle Schematic and Board layout design for simple opamp module questions
Hopefully I'm not doing anything illegal, I posted a very similar question a few days ago, but this one is different.
Here is what I've been working on the past couple days, trying out different ...
