12
\$\begingroup\$

What is the purpose of the two 1N4148 diodes used in this circuit?

enter image description here

Regards

Edit:Source page of the circuit..

http://www.radanpro.com/Radan2400/Video/TV%20remote%20control%20blocker-jammer%20circuit%20diagram.htm

\$\endgroup\$
1
  • \$\begingroup\$ Sure ...i don't know what this circuit do... I found it while searching about it circuit ^^ \$\endgroup\$
    – armma
    Jun 16, 2018 at 22:00

1 Answer 1

29
\$\begingroup\$

When pin 3 of the timer is low, the voltage at the base of the transistor is about 1.4 V below Vcc, and therefore the voltage across the 180 \$\Omega\$ resistor is around 0.7 V. So the current through the transistor and LED's is about 3.9 mA, regardless of variations in supply voltage (which I guess is a 9 V battery, and can vary a lot). Hence the LED's should stay at the same brightness for a wide range of supply voltage.

In a few words - it's a current source circuit. (Good one to memorize, it comes up a lot. The other common way is to use a zener instead of the two diodes.)

\$\endgroup\$
1
  • 1
    \$\begingroup\$ +1 A variation is to replace the two series diodes (~1.4V) with a red LED (~1.8V), which gives you an indicator LED for free. \$\endgroup\$ Jun 17, 2018 at 13:23

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.