I want to figure out the best way to solder each terminal of a screw terminal block to a row of this proto board that has square pads. None of the squares are electrically connected. I assume just a wire on the bottom side for each terminal could work but maybe there is a more elegant solution:
UPDATE
I ended up using some of the suggested ideas and a few of my own. This was my first time using a square pad proto board and it was relatively easy to use. I routed the wires on the top side and was able to bend the leads over to the locations of the screw terminals on the bottom side. I am still a beginner so it is not perfect but it works:
This image helped my thinking of how to do this (not sure the source):
I thought that this track soldering instructables was helpful: https://www.instructables.com/Track-Soldering/
I also liked some of the boards I found here: How to solder PCB?