4
\$\begingroup\$

In Eagle Cad 6.4 is there a way to toggle between "real" and "outline" mode? The Ratsnest command will pour and display the flood fill. I simply want to return the display back to way it was prior,outline for easier visibility - Back and Forth.

I see that "ripup *" will do it. but it will also ripup the routes. In other CAD's one can simply redraw and the pour is simply omitted. I also see "SET POLYGON_RATSNEST OFF" will prevent the pours from filling. But does not un-draws the fills.

At the moment the only way I can see is to close and reopen the file.

\$\endgroup\$
3
  • 1
    \$\begingroup\$ I only know Eagle 5.x, but isn't performing a ripup by clicking on the edge of the filled polygon doing the trick? \$\endgroup\$
    – Rev
    Jul 4, 2013 at 18:24
  • \$\begingroup\$ @Rev1.0 That works in Eagle 6 too. \$\endgroup\$
    – us2012
    Jul 4, 2013 at 18:24
  • \$\begingroup\$ @us2012: Thanks for the confirmation, i posted this as an answer. \$\endgroup\$
    – Rev
    Jul 4, 2013 at 18:32

2 Answers 2

2
\$\begingroup\$

Perform a partial rip-up by clicking on the edge/perimeter of the filled polygon. This will just "clear" the polygon and leave everything else from the signal intact.

\$\endgroup\$
2
\$\begingroup\$

"ripup @;" will clear the copper pour

\$\endgroup\$
0

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.