2 added 1 characters in body
source | link

In my experience, vertical resistors are very common in cost-sensitive, hand-soldered products (in other words: cheap products from China). So I think your are making a good decision when cost is a major concern.

But I am a bit surprised that PCB area is a major cost driver in a prototype, especially when there are only two TH resistors?

In my experience hand soldering a horizontal resistor is much easier because they tend not to fall out of the bordboard when you flip the boradboard over, so I prefer horizontal resistors, especially in prototypes!

In my experience, vertical resistors are very common in cost-sensitive, hand-soldered products (in other words: cheap products from China). So I think your are making a good decision when cost is a major concern.

But I am a bit surprised that PCB area is a major cost driver in a prototype, especially when there are only two TH resistors?

In my experience hand soldering a horizontal resistor is much easier because they tend not to fall out of the bord when you flip the borad over, so I prefer horizontal resistors, especially in prototypes!

In my experience, vertical resistors are very common in cost-sensitive, hand-soldered products (in other words: cheap products from China). So I think your are making a good decision when cost is a major concern.

But I am a bit surprised that PCB area is a major cost driver in a prototype, especially when there are only two TH resistors?

In my experience hand soldering a horizontal resistor is much easier because they tend not to fall out of the board when you flip the board over, so I prefer horizontal resistors, especially in prototypes!

1
source | link

In my experience, vertical resistors are very common in cost-sensitive, hand-soldered products (in other words: cheap products from China). So I think your are making a good decision when cost is a major concern.

But I am a bit surprised that PCB area is a major cost driver in a prototype, especially when there are only two TH resistors?

In my experience hand soldering a horizontal resistor is much easier because they tend not to fall out of the bord when you flip the borad over, so I prefer horizontal resistors, especially in prototypes!