For now, I'm sending bytes from FPGA (verilog) to serial at 115200 bps.

I would like to send at higher speed and connect to a bluetooth module (RN42).

• UART (SPP or HCI) and USB (HCI only) data connection interfaces.
• Sustained SPP data rates - 240Kbps (slave), 300Kbps (master)
• HCI data rates - 1.5Mbps sustained, 3.0Mbps burst in HCI mode

Then, now, I would like to implement a HCI UART in order to get max 3 Mbps.

I didn't find anything clear about how to implement this.

Could you help me? What's change? Should I just send my data to higher bps and it's done?

It's the first time I'm trying to implement another way to send data than serial.

For now, I'm sending bytes from FPGA (verilog) to serial at 115200 bps.

I would like to send at higher speed and connect to a bluetooth module (RN42).

• UART (SPP or HCI) and USB (HCI only) data connection interfaces.
• Sustained SPP data rates - 240Kbps (slave), 300Kbps (master)
• HCI data rates - 1.5Mbps sustained, 3.0Mbps burst in HCI mode

Then, now, I would like to implement a HCI UART in order to get max 3 Mbps.

I didn't find anything clear about how to implement this.

Could you help me? What does change? Should I just send my data at higher bps and it's done?

It's the first time I'm trying to implement another way to send data than serial.

For now, I'm sending bytes from FPGA (verilog) to serial at 115 200bps.

I would like to send at higher speed and connect to a bluetooth module (RN42).

- UART (SPP or HCI) and USB (HCI only) data connection interfaces.
- Sustained SPP data rates - 240Kbps (slave), 300Kbps (master)
- HCI data rates - 1.5Mbps sustained, 3.0Mbps burst in HCI mode

Then, now, I would like to implement a HCI UART in order to get max 3Mbps.

I didn't find anything clear about how to implement this.

Could you help me  ? What's change  ? Should I just send my data to higher bps and it's done  ?

It's the first time I'm trying to implement another way to send data than serial.

Thank you !

For now, I'm sending bytes from FPGA (verilog) to serial at 115200 bps.

I would like to send at higher speed and connect to a bluetooth module (RN42).

• UART (SPP or HCI) and USB (HCI only) data connection interfaces.
• Sustained SPP data rates - 240Kbps (slave), 300Kbps (master)
• HCI data rates - 1.5Mbps sustained, 3.0Mbps burst in HCI mode

Then, now, I would like to implement a HCI UART in order to get max 3 Mbps.

I didn't find anything clear about how to implement this.

Could you help me? What's change? Should I just send my data to higher bps and it's done?

It's the first time I'm trying to implement another way to send data than serial.