Skip to main content

Timeline for USB C to USB A pinout

Current License: CC BY-SA 3.0

12 events
when toggle format what by license comment
Mar 31, 2020 at 14:29 comment added endolith There's never been a "traditional Rx / Tx". Where did you get that from?
Mar 11, 2017 at 5:41 comment added Ale..chenski Your terminology is confusing. So, you are designing a DEVICE. If your other connected device (microprocessor) has OTG port, it will select the host mode automatically as soon as it will see 5.1K pull-down from your DEVICE
Mar 10, 2017 at 16:03 comment added Ignatius_Gim This is for an device which would need to initiate OTG mode on its connected device, I need to be able to read the serial data from the connection with a microprocessor
Mar 10, 2017 at 13:54 history tweeted twitter.com/StackElectronix/status/840199269290278912
Mar 10, 2017 at 2:49 answer added Ale..chenski timeline score: 14
Mar 10, 2017 at 2:41 comment added Ale..chenski Again, is this for a host, of for a device?
Mar 10, 2017 at 2:07 vote accept Ignatius_Gim
Mar 10, 2017 at 1:47 answer added Passerby timeline score: 19
Mar 10, 2017 at 1:09 comment added Ignatius_Gim @DoxyLover, thank you. I was looking at some old pinout diagrams.
Mar 10, 2017 at 0:53 comment added Ale..chenski Are you implementing a USB2 port, or a full-blown USB 3.1 communication?
Mar 10, 2017 at 0:47 comment added DoxyLover USB 2 and earlier has never had Tx/Rx! It's a single differential pair D+/-. Note that the key at the bottom of your diagram shows purple as "USB High Speed 480Mbps" and those are the D+/- so there's your answer!
Mar 10, 2017 at 0:41 history asked Ignatius_Gim CC BY-SA 3.0