Timeline for USB C to USB A pinout
Current License: CC BY-SA 3.0
11 events
| when toggle format | what | by | license | comment | |
|---|---|---|---|---|---|
| Mar 29, 2021 at 22:38 | comment | added | Ale..chenski | @JohnEvans, the current SNPS document says: "To convert an existing USB 2.0 device to Type-C, the designer must add two pull-down resistors to the CC pins". Apparently SNPS has corrected their marketing document since. | |
| Feb 3, 2019 at 17:03 | comment | added | John Evans | I'm reading here: synopsys.com/designware-ip/technical-bulletin/… : "o convert an existing USB 2.0 device to USB Type-C, the designer can short the two CC pins, add one Pull-Down resistor and route the USB D+/D- signals to both positions on the USB Type-C receptacle" Should I short the cc pins? Or just connected them to ground with their own 5K pull-down resistors? | |
| Mar 11, 2017 at 5:50 | history | edited | Ale..chenski | CC BY-SA 3.0 |
added 35 characters in body
|
| Mar 11, 2017 at 5:43 | comment | added | Ale..chenski | You probably need to clarify then which "device" you are talking about, the OP's device, or the "partner microprocessor OTG device" | |
| Mar 10, 2017 at 16:11 | comment | added | Passerby | Pulling both CC pins to ground with a 5K resistor places the device in OTG mode if the device supports OTG mode. | |
| Mar 10, 2017 at 16:04 | comment | added | Ignatius_Gim | So how would you initiate OTG mode? | |
| Mar 10, 2017 at 4:41 | comment | added | Passerby | @alichen plurals. Nice catch. | |
| Mar 10, 2017 at 4:40 | history | edited | Passerby | CC BY-SA 3.0 |
added 2 characters in body
|
| Mar 10, 2017 at 2:07 | vote | accept | Ignatius_Gim | ||
| Mar 10, 2017 at 1:52 | history | edited | Passerby | CC BY-SA 3.0 |
added 99 characters in body
|
| Mar 10, 2017 at 1:47 | history | answered | Passerby | CC BY-SA 3.0 |