2 added 55 characters in body
source | link

In ModelSim, I can click compile and ModelSim will compile it quickly, around 1 or 2 seconds.

But in Quartus Prime, I need to run Analysis & Elaboration or Analysis & Synthesis which runs more than 40 seconds for the same code which takes only 1 or 2 seconds to compile in ModelSim.

I know Analysis & Synthesis will perform Synthesis as well, but sometimes I need to just check whether my code has error or not without the need to synthesis.

Until now, I have been going back and forward between those two CAD tools.

Any suggestion will be appreciated.

In ModelSim, I can click compile and ModelSim will compile it quickly, around 1 or 2 seconds.

But in Quartus Prime, I need to run Analysis & Elaboration or Analysis & Synthesis which runs more than 40 seconds for the same code.

I know Analysis & Synthesis will perform Synthesis as well, but sometimes I need to just check whether my code has error or not without the need to synthesis.

Until now, I have been going back and forward between those two CAD tools.

Any suggestion will be appreciated.

In ModelSim, I can click compile and ModelSim will compile it quickly, around 1 or 2 seconds.

But in Quartus Prime, I need to run Analysis & Elaboration or Analysis & Synthesis which runs more than 40 seconds for the same code which takes only 1 or 2 seconds to compile in ModelSim.

I know Analysis & Synthesis will perform Synthesis as well, but sometimes I need to just check whether my code has error or not without the need to synthesis.

Until now, I have been going back and forward between those two CAD tools.

Any suggestion will be appreciated.

1
source | link

What is the equivalent of compile of modelsim in quartus prime?

In ModelSim, I can click compile and ModelSim will compile it quickly, around 1 or 2 seconds.

But in Quartus Prime, I need to run Analysis & Elaboration or Analysis & Synthesis which runs more than 40 seconds for the same code.

I know Analysis & Synthesis will perform Synthesis as well, but sometimes I need to just check whether my code has error or not without the need to synthesis.

Until now, I have been going back and forward between those two CAD tools.

Any suggestion will be appreciated.