Timeline for Transistor as a heater device and measured by LM35 temperature sensor?
Current License: CC BY-SA 4.0
8 events
when toggle format | what | by | license | comment | |
---|---|---|---|---|---|
Jan 19, 2020 at 15:14 | vote | accept | Tareq | ||
Jan 19, 2020 at 3:11 | comment | added | D.A.S. | Do you realize you have unspecified requirements? Or do you just want to regulate the TIP temp? | |
Jan 18, 2020 at 23:57 | history | edited | JRE | CC BY-SA 4.0 |
Cleaned up grammer, punctuation, captalization.
|
Jan 18, 2020 at 22:54 | answer | added | Spehro 'speff' Pefhany | timeline score: 1 | |
Jan 18, 2020 at 22:49 | comment | added | D.A.S. | Define mass of all targets being heated and temperature difference above ambient. Also indicate acceptable overshoot or rate of change of T. THis is probably just a linear control system. | |
Jan 18, 2020 at 22:47 | answer | added | user69795 | timeline score: 0 | |
Jan 18, 2020 at 22:33 | comment | added | Transistor | Your post would be a bit more easily read if you capitalised sentences, part numbers, brand names and electrical symbols properly. If English is not your first language then add that into your user profile so we can help you out. Use a power resistor as the heater rather than the transistor and that way you can switch the resistor on and off using the transistor which when fully off (zero power dissipation in it) and when fully on (very low dissipation in it) as the voltage drop across it will be so low. | |
Jan 18, 2020 at 22:23 | history | asked | Tareq | CC BY-SA 4.0 |