I am facing a strange issue. My waveform color changes when I add a .STEP command in my circuit.

NOTE: I am aware of the following problem, but my problem is little different.

LTspice: How can I show multiple probes with waveforms using stepping parameters in different colors?

The following is the simple circuit. I am just checking the input signal on the waveform:

After this I used the STEP command for the capacitor. The output waveform is not even added into the plot pane but the color on my input waveform is changed. It should be green.

And again:

It is not a major issue, but I still wanted to understand if there is a way to fix this, or if I am doing something wrong.

I am facing a strange issue. My waveform color changes when I add a .STEP command in my circuit.

NOTE: I am aware of the following problem, but my problem is little different.

LTspice: How can I show multiple probes with waveforms using stepping parameters in different colors?

The following is the simple circuit. I am just checking the input signal on the waveform:

Edited: 15-July-2022
(NOTE: Maybe my question is not so clear, my doubt is not in the color of Vout signal, the doubt is that when STEP command is added, the color of Vin signal on plot/waveform is changed and unfortunately I can't control it, means I can't change the color it's always red in my case)

After this I used the STEP command for the capacitor. The output waveform is not even added into the plot pane but the color on my input waveform is changed. It should be green.

And again:

It is not a major issue, but I still wanted to understand if there is a way to fix this, or if I am doing something wrong.

I am facing a strange issue, my waveform color changes when I add .STEP command in my circuit.

NOTE: I am aware of the following problem, but my problem is little different.  LTspice: How can I show multiple probes with waveforms using stepping parameters in different colors?

The following is the simple circuit and I am just checking the Input Signal on Waveform

After this I used the STEP command for Capacitor, and the output waveform is not even added into the plot pane, and the color on my input waveform is changed, while it should be green in color.  

And still.

For me not an major issue, but still wanted to understand if there is a way to fix this, or I am doing something wrong.

Thanks in advance.

I am facing a strange issue. My waveform color changes when I add a .STEP command in my circuit.

NOTE: I am aware of the following problem, but my problem is little different. 

LTspice: How can I show multiple probes with waveforms using stepping parameters in different colors?

The following is the simple circuit. I am just checking the input signal on the waveform:

After this I used the STEP command for the capacitor. The output waveform is not even added into the plot pane but the color on my input waveform is changed. It should be green. 

And again:

It is not a major issue, but I still wanted to understand if there is a way to fix this, or if I am doing something wrong.