Previously asked & solved:

Pin Assignment in ispLEVER Classic

Typical file location as example:

C:\ispTOOLS5_1_....\examples\spld\gal\mlcount editing the .tt3 file then :

"After done, just run the 'Fit design' (+create fuse map) again and voila, you have the right signals at the right place."

Slightly more detail:

Open "examples" in isplever, choose and open mlcount.syn

"create fuse map".

New file appears .tt3 (make a backup) Open in txt editor.

"#$ PINS ....." is the line you are looking to modify in your code. Save your edited file and re-run "create fuse map".

Thanks to who linked the link.

Previously asked & solved:

Pin Assignment in ispLEVER Classic

Typical file location as example:

C:\ispTOOLS5_1_....\examples\spld\gal\mlcount editing the mlcount.tt3 file then :

"After done, just run the 'Fit design' (+create fuse map) again and voila, you have the right signals at the right place."

Slightly more detail:

Open "examples" in isplever, choose and open mlcount.syn

"create fuse map".

New file appears mlcount.tt3 (make a backup)

Open mlcount.tt3 in txt editor.

"#$ PINS ....." is the line you are looking to modify in your code.

Save your edited file and re-run "create fuse map". (be sure your edited file saved is ".tt3" and not ".tt3.txt"

Thanks to who linked the link.