Timeline for Emergency stop behavior - state of normally open switch when activated
Current License: CC BY-SA 4.0
8 events
| when toggle format | what | by | license | comment | |
|---|---|---|---|---|---|
| Oct 15 at 21:10 | history | bumped | CommunityBot | This question has answers that may be good or bad; the system has marked it active so that they can be reviewed. | |
| Jun 7 at 4:04 | history | bumped | CommunityBot | This question has answers that may be good or bad; the system has marked it active so that they can be reviewed. | |
| Jul 16, 2023 at 6:36 | answer | added | vu2nan | timeline score: 0 | |
| Jul 15, 2023 at 17:47 | comment | added | Siva | This one only has one normally open circuit (the button has for pins, two for the normally closed switch and two for the normally open). The normally open circuit is 5V from an Arduino, the NO switch and a 10K pull-down resistor. This is is wired to a digital in pin of the Arduino. | |
| Jul 15, 2023 at 17:33 | answer | added | user319836 | timeline score: 0 | |
| Jul 15, 2023 at 17:24 | comment | added | Mister Mystère | That's unusual (I think). Are you sure? I think I remember that most emergency stops can have 2 circuits normally closed that latch open. You can use that for your detection circuit. What's downstream? | |
| S Jul 15, 2023 at 17:18 | review | First questions | |||
| Jul 15, 2023 at 17:39 | |||||
| S Jul 15, 2023 at 17:18 | history | asked | Siva | CC BY-SA 4.0 |