I am trying to find the connector type (see links below) for some time with out success.
The pitch is 1.25mm.
Also the "Shrouded Header WR-WTB" is really similar but the "key" is not in the center.Also the pins are closer to the pcb in my connector.
2
-
1\$\begingroup\$ Possibly some Molex copy cat? \$\endgroup\$– LundinMar 3, 2014 at 13:36
-
\$\begingroup\$ The "Shrouded Header WR-WTB" is really similar but the "key" is not in the center.Also the pins are closer to the pcb in my connector. \$\endgroup\$– HugoMar 3, 2014 at 13:41
Add a comment
|
1 Answer
\$\begingroup\$
\$\endgroup\$
2
If the pitch of the connector is 1.25mm, then it might be 1734261-4 from TE Connectivity. Please check the datasheet of the connector from the link.
-
\$\begingroup\$ Thanks a lot. The pitch is hard to measure with a big caliper. \$\endgroup\$– HugoMar 3, 2014 at 14:14
-
\$\begingroup\$ I agree. :) However, please verify all the relevant dimensions from the datasheet with the component which you have on board. \$\endgroup\$– AvinMar 3, 2014 at 14:24