1
\$\begingroup\$

I am using a library part in my Eagle PCB schematic. I would love to learn more about what's inside / what sub-components the library owner used to make it. Is there any way to do this? For example without the internal parts list I have no idea how to estimate the cost.

I tried the run bom.ulp command which didn't work (it only showed the top-level module as being a part in the BOM).

Here is the library in particular I've imported: http://forum.pjrc.com/threads/935-Eagle-library-with-Teensy-3-0-footprint?p=20178&viewfull=1#post20178

Cheers

Improve this question
\$\endgroup\$
1
\$\begingroup\$

What you got is a footprint for a teensy connector. There is no information in that about the teensy itself.

Improve this answer
\$\endgroup\$
5
  • \$\begingroup\$ What does this mean and how should I proceed? \$\endgroup\$ – JDS Apr 1 '14 at 13:34
  • \$\begingroup\$ Towards what end? If you want information about the teensy itself I'm sure you can find that by googling. \$\endgroup\$ – Wouter van Ooijen Apr 1 '14 at 13:40
  • \$\begingroup\$ Sorry let me be more specific. Can I take this library part and fabricate a teensy board with it and extend, e.g. connecting a sensor to a GPIO? I was concerned that since I wasn't able to generate a BOM I might not be able to use it for my design \$\endgroup\$ – JDS Apr 1 '14 at 13:46
  • 1
    \$\begingroup\$ From the discussion you got it from I read that this is a library for a teensy FOOTPRINT, that is: you can plug an existing teensy in it, and make connections to it. You can not use it to MAKE a teensy. \$\endgroup\$ – Wouter van Ooijen Apr 1 '14 at 13:53
  • \$\begingroup\$ Ahh, see I had no idea what a "footprint" was. Thanks, I guess this part isn't appropriate for me to use then. \$\endgroup\$ – JDS Apr 1 '14 at 13:54

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.