A couple of times when taking apart older bits of electronics, I've seen a small neon lamp about the size of a fuse (but its definitely not a fuse) positioned near the power supply circuitry. What is its purpose?

Is it used as some kind of input protection? Does it illuminate under fault conditions? Why not use a MOV or some other purpose designed component?

  • \$\begingroup\$ was it in the primary winding circuit or any high voltage secondary ? \$\endgroup\$
    – greg
    May 27, 2014 at 14:00

3 Answers 3


It is used as discharger for overvoltage conditions - in case of overvoltage a discharge starts through the lamp and that protects the main circuit from overcurrent.

A neon lamp is used because it is relatively cheap, very reliable and there's zero current through the lamp until the discharge actually starts.

  • 2
    \$\begingroup\$ +the only downside to Neon lamps is the relatively high input capacitance (when open) and the high steady state voltage. MOVs and TVses go down to tens or single-digit picofarad ratings, and when they clamp, they clamp to a lower voltage with lower impedance. That is why eventually MOVs and TVSes won out. Otherwise a Ne lamp is functionally the same as an MOV. \$\endgroup\$
    – user36129
    May 22, 2014 at 15:22
  • 1
    \$\begingroup\$ You will also encounter these on old network-interfaces (for coax networks). For exactly the same reason. To discharge over-voltage that can buildup in the coax cable by itself or is caused by static discharge from people touching the connectors. \$\endgroup\$
    – Tonny
    May 22, 2014 at 15:23

Another perspective would be for safety during troubleshooting. From the venerable Bob Pease:

So, whenever I start work on a high-voltage circuit, I tack in a neon lamp in series with a 100k resistor across the high-voltage busses. Then when I see the neon's glow, I'm graphically reminded that this really is a high-voltage circuit, and that the power is still ON (I don't care what the power switch says) and I should revert to the mode of High-Voltage Cautions. If I grab onto a really hot wire, the shock might not injure me, but I might convulse and jerk backwards. That's not a good idea if I'm standing on top of a ladder, for instance. So, looking for the glow of a neon lamp is a way to remind me to be serious, and I recommend it for you, too.

From http://electronicdesign.com/electromechanical/whats-all-reflex-response-stuff-anyhow

  • 1
    \$\begingroup\$ Glad to hear Bob Pease quoted. +1 just for old times. Another +1 because he knew how reality connected. Any young timers, do a search on this venerable old man. And the answer is quite correct. \$\endgroup\$
    – Marla
    May 23, 2014 at 0:46

On some old electronics (especially during vacuum tube era) the neon bulb was put in parallel with a fuse and used as a blown fuse indicator. Other times it was merely a power applied indicator (pilot lamp).


Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.