1
\$\begingroup\$

I'm trying to make a latching power switch based off this schematic (source: EDN) push button latching power circuit

I emulated the circuit in Falstad and everything works like it should (link to simulation).

However, it doesn't work when assembled on a PCB. When I click the button, I see a sudden spike at Vout from 0 to 0.2V and then it quickly settles back to zero. I'm seeing no behavior that is similar to the simulation. I'm now starting to think I selected the wrong MOSFET/Transistor for the job, but I'm not sure which property would effect the circuit.

Here are some more details about my imlementation:

  • Vs - LiPo Battery (3.9 to 4.2 V Nominal)
  • Desired Vout - mirrors +Vs
  • Mosfet - FDN352AP
  • Transistor - MMBT2222A

Any thoughts? This is the first analog circuit I've built (simulated a few), so not really sure where to start looking.

\$\endgroup\$
1
\$\begingroup\$

This issue is solved. The circuit was failing due to a faulty isolation diode earlier in the circuit.

\$\endgroup\$

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.