5
\$\begingroup\$

I'm trying to import a Schematic to PCB in Altium and I get this message that there are unmatched nets cropping up:

unmatched nets

The PCB is empty, I've searched in the Schematic for them but I can't find them. Do I match them or is there a way to delete them? I don't understand why they're in the first place....

\$\endgroup\$
8
\$\begingroup\$

Turns out it was sort of an artifact from earlier PCB 'experiments' on the same board when it wasn't done, went to Design -> Netlist -> Clear all Nets which solved the problem.

\$\endgroup\$
  • \$\begingroup\$ Oh my gosh, thank you for that, I've been tearing what little hair I have out over this. Have ten points! \$\endgroup\$ – DiBosco Aug 23 '18 at 14:39

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.