Could STM32S003F3 be flashed with SWIM interface only (SWIM, RST, VCC, GND, bare IC without any other elements)? I'm trying to flash it with ST-LINK/V2 and last version of IAR (Kickstart) and debugger reports that:

Errors while setting configuration with MCU name STM8S003F3: gdi-error [40409]: No answer from the SWIM: check chip connections and power supply; try a power on reset

So i'm wondering where could be the trouble :(


The problem was obvious - STM32S003 can't work without capacitor at VCAP pin. So adding that capacitor will fix the problem.

| improve this answer | |

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.