Why is voltage output inverted between common-emitter and common-collector amplifiers?

My resource shows the following common-emitter transistor configuration and claims that the output voltage compared to the input voltage is inverted (higher input voltage means lower output voltage): This makes sense to me. But then he shows the following common-collector transistor configuration and claims that the output voltage grows directly with the input voltage (higher input voltage means higher output voltage): The author makes the claim that a key distinction between common-emitter and common-collector configurations is the fact that the output signals are inverse. This doesn't make sense to me because he seems to be measuring the "output voltage" at different points in each circuit. In the common emitter circuit, he uses the voltage across the two leads of the transistor as his output voltage. In the common collector circuit however, he uses the voltage drop across the load.

How can he claim that these circuits differ in the nature of their output voltage when it's really just him measuring the voltage drop across different points in the circuit? If in the common-emitter circuit, he measured the output voltage as the voltage drop across the resistor R, would he not receive an output voltage similar to that of the output voltage in the common collector circuit? Where am I mistaken?

• Circuit 2 is also called an emitter follower. The base-emitter voltage is approx 0.7 when Vin>0.7, and then Vout+Vbe=Vin, or Vout = Vin - 0.7. So the output follows the input with a -0.7V offset – Chu Apr 22 '15 at 0:22

In both cases, the output voltage is measured between 'ground' and whichever point has been defined as the output for that circuit configuration.
So in a common-emitter circuit (1), the output is defined as being at the collector.
But in a common-collector circuit (2), the output is defined as being at the emitter.
In the first circuit, R is not the load.
The load resistor is only present in circuit 2 to make analysis of it easier (since there would be undefined variables without it).

• The resistor in circuit 2 is required to make it work, i.e. to prevent the output voltage being zero. – user207421 Apr 21 '15 at 23:04

No, you are mistaken in your analysis. When the base is driven harder in a common collector NPN circuit, the transistor passes more current from collector to emitter and this raises the emitter voltage with respect to 0V.

In a common emitter circuit, with a higher base drive, the collector voltage falls towards 0V potential.

You're right: in the CE circuit, if he were to measure the output voltage across the resistor, the voltage would increase with increasing input voltage. He is running with the assumption, however, that all signals are ground-referenced: from this perspective, the output voltage must be taken across the transistor instead.

However, the output voltages are not the same in magnitude. In the CE circuit, the amplitude of the output voltage may be greater (or smaller, depending) than that of the input voltage, whereas in the CC circuit the output voltage is strictly smaller than the input voltage.