0
\$\begingroup\$

I have a HDMI switch that I want to control with an Arduino. It's working by pressing a button to change input signal. The button is NC(Normally Close). By pressing the button you break the 3.3V going throw it.

I want so when you send 5V from Arduino you to break the switch of the 3.3V. What component is best for doing this? Will a transistor work? Doesn't it mean I need to apply 5V all the time except when breaking the switch.(Don't want that)

  • Is there any MOSFET that will work?
  • I have been looking at CMOS 4066?, is that a good IC for the job?
  • Or is there any relay IC that work?
\$\endgroup\$
1
\$\begingroup\$

I'd recommend a bistable mechanical relay. Advantages:

  • Electrically isolate your Arduino and HDMI switch
  • Holds either state without power (especially useful for noise suppression)
  • No voltage drop across closed contacts; exactly replicates electrical properties of the switch you'd replace

A quick search revealed a candidate (PB1618-ND) with bistable operation perfect for an Arduino; a 5V-rated coil draw of 12 mA. The contacts are rated for 1A @ 125VDC, which should be plenty for a little switch.

\$\endgroup\$
  • \$\begingroup\$ thank you vary much for the help. That component is a bit big an would not fit within the case of the switch. I did try 2 component together.A CMOS 4066 and a 36-110 relay switch. I have just test it with a LED yet but the function work fine. Or can the CMOS 4066 have any effect on the 3.3V? \$\endgroup\$ – Ehel May 4 '15 at 19:19
  • \$\begingroup\$ A quick peek at a CMOS4066 datasheet seems to indicate that in the 'on' state, it acts as a resistor. So you may run into trouble if this conflicts with a pullup/pulldown resistor built into your HDMI switch. \$\endgroup\$ – Jay J May 5 '15 at 4:01

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.