4
\$\begingroup\$

I am trying to build a tube amp without using any semiconductors (just for the fun of it, trying to make it using the technology that was available when tube amps were mainstream). I may need to control some relays in it, however, I cannot figure out how, or rather, how to do it properly.

I have some thyratrons (both hot and cold cathode) and obviously some vacuum tubes. I may have to:

  1. turn a relay on or off with a pulse (like a push button)
  2. Switch between two relays (one off one on)
  3. have a relay turn on for some time then turn off (shorting the output of the amp for a few seonds to avoid a pop when switching inputs etc).

How do I do it without semiconductors? I currently do not have a specific application in mind, just looking to learn more.

\$\endgroup\$
3
\$\begingroup\$

To 1st and 2nd problem you need a simple flip-flop. You can make it from two triodes or one dual triode. Look at this schematic from DRTE Computer site:

enter image description here

Outputs are on anodes of tubes. One output have high level and other have a low level, trigger pulse swap levels of outputs. There are many vacuum-tube flip-flops like this one, similar in construction, and all of them have its origin in first ever know digital circuit: Eccles-Jordan flip-flop.

Solution to the 3rd problem is single-shot multivibrator:

enter image description here

Output is on the A2 anode. Values of R and C connected to A1 anode gives You a time of output pulse duration. This circuit comes from P.Neeteson book "Vacuum valves in pulse technique", page 117. Another circuit You may found here: http://mysite.du.edu/~etuttle/electron/elect36.htm

There are also other solution to control relays without transistors and also without tubes - You may use only relays. But I suppose that it will be hard to find old "non-electronic" (fully electro-mechanical) pulse-trigerred and time delay relays - eBay and flea-markets should be Your friends.

\$\endgroup\$
  • \$\begingroup\$ Completely forgot about flip-flops. I guess when I am thinking about tubes I am not thinking about digital circuits. \$\endgroup\$ – Pentium100 May 25 '15 at 11:57

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.