I am using Altium designer 15.
How can you rotate a component by 45 degree in PCB mode?
Regards, MathieuL
\$\begingroup\$
\$\endgroup\$
Add a comment
|
1 Answer
\$\begingroup\$
\$\endgroup\$
2
I know that there are a few ways of doing it, but this is the way I use (because I can't remember the other way and it wasn't important enough for me to find out).
Go to your preferences PCB editor Under the "Other" section, change rotation step to 45deg.
-
7\$\begingroup\$ +1 Or just select the component properties (right-click) and type in 45 or -45 for "Rotation". Or any other angle that suits your fancy. \$\endgroup\$ Commented Jun 26, 2015 at 20:18
-
2\$\begingroup\$ It is available to rotate multiple (or single) components with Edit --> Move --> Rotate Selection, add angle then left-click. \$\endgroup\$ Commented Jun 26, 2015 at 23:56