I have 4 op-amps in cascade with a gain of 10 each to give a total gain of 10000. I noticed the circuit produces a DC offset which then gets amplified causing the amplified signal to clip asymmetrically.

I know op-amps have an offset pin but I have never used it before and I am looking for the simplest solution. I thought I might simply add a capacitor after each op-amp but I don't know how large it should be or if it would help. The signal I am amplifying is 40 kHz.

What is my best option?

  • \$\begingroup\$ Some but not all op-amps have an offset pin. The dual DIP8/SO8 (e.g NE5532 and what not) normally don't have it because there's no room for it. \$\endgroup\$ Sep 22, 2015 at 19:20
  • \$\begingroup\$ Yeah just AC couple between stages with a cap and resistor to ground. Maybe 1 uF and 100 k ohm. (time constant =0.1s, freq ~100 Hz) You can pick the corner frequency of the high pass filter to fit your application. \$\endgroup\$ Sep 22, 2015 at 19:20
  • 2
    \$\begingroup\$ What op-amp are you using and what bandwidth is your signal? \$\endgroup\$
    – Andy aka
    Sep 22, 2015 at 20:14

3 Answers 3


Of course you can try to compensate for the DC offset but why not eliminate the influence of DC offset in the first place ? You can do this if you do not need 10000 times gain at DC. You mention that your signal is 40 kHz, I conclude from that the DC value is irrelevant to you. Then I would just make amplifiers that have 10 x gain at 40 kHz but 1 x gain at DC !

Here's an example of how I would do that:


simulate this circuit – Schematic created using CircuitLab


The equation for the capacitor is rather simple. The capacitor will interfere with frequencies lower than \$f = {1 \over {2\pi RC}}\$ where R is the input impedance of the next stage. Simply substitute the desired minimum frequency and impedance, solve for capacitance, and pick a larger value.

  • \$\begingroup\$ @Ace: Also don't just add caps. Once your amp stages are AC-coupled you can run into funny problems if there's no DC path for the input bias currents. \$\endgroup\$ Sep 22, 2015 at 19:31

If you are stuck with being only-able to replace the op-amps then....

Just use much better op-amps. You can get zero drift op-amps that have less than 10uV offset voltage - altogether that's 11.11mV at the output with regular DC coupling and all the offsets pointing the same way. 40kHz is a breeze for a lot of them - gain-bandwidth-product required is minimum 400kHz and this is also easily achievable. Check out TI, ADI and LT for offerings.


Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.