1
\$\begingroup\$

Is it possible to damage a vacuum tube or gas-filled tube while soldering to it (thermal shock?), and if so, are there any special precautions that should be taken while soldering tubes to avoid damage?

\$\endgroup\$
3
  • 3
    \$\begingroup\$ More often than not, they're socketed. No heat required. \$\endgroup\$
    – Matt Young
    Feb 26, 2016 at 22:52
  • \$\begingroup\$ Almost universally "no", but what specific tubes or family of tubes do you have in mind? \$\endgroup\$
    – EM Fields
    Feb 26, 2016 at 22:53
  • \$\begingroup\$ What got me wondering about this was Adafruit's now-discontinued vacuum fluorescent display clock - the instructions require the IV-18 VFD to be soldered directly to a PCB which then has a connector that plugs into a socket. I am now trying to build my own VFD clock using a salvaged VFD. The only issue I have is that the pins are unusually shaped and will not fit into any standard socket. \$\endgroup\$
    – 3871968
    Feb 26, 2016 at 22:56

1 Answer 1

1
\$\begingroup\$

Thermal Paste and a slow heating process with a reflow gun would probably work well. The various glass parts should heat up slowly compared to a soldering iron, and the temperatures can be kept lower. I would suggest soldering either extension wires or some other heat resistant thing, so that the salvaged parts are easier to work with during prototyping.

\$\endgroup\$
1
  • \$\begingroup\$ How about, whenever possible, holding the leg with a pair of needle-nose pliers between the device and the place being soldered? That won't always be practical, but I think it should pretty reliably keep the device from getting too hot. \$\endgroup\$
    – supercat
    May 25, 2016 at 15:07

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.