2
\$\begingroup\$

I have laid out this board that includes (among other lower speed connections) a 1 upstream and 2 downstream ports on a 0.5mm FR4. The USB differential traces are 0.6mm wide with 0.15mm spacing between them. Can you give your opinion if this is going to work?

It's an open-source project, here is the link : https://tools.upverter.com/eda/#tool=pcb,designId=6f8c466dba06e940

Thanks for you time.

\$\endgroup\$
3
  • \$\begingroup\$ What does your fab say you should do for 90 ohm controlled impedance? Are those values the result of a PCB impedance calculator? Is there a ground plane on the other side? \$\endgroup\$
    – pjc50
    Apr 13, 2016 at 11:00
  • \$\begingroup\$ Having looked (slowly) at your PCB,it looks like they're short enough that it will make little difference unless you're trying to push the full 5m USB cable length. I can't see any ESD protection which may be a problem in production. See also electronics.stackexchange.com/questions/41851/… \$\endgroup\$
    – pjc50
    Apr 13, 2016 at 11:06
  • \$\begingroup\$ Thank you for your comments. The values are a result of this PCB impedance calculator, eeweb.com/toolbox/edge-coupled-microstrip-impedance, and yes in the bottom copper (which I guess you have already seen there is a ground pour). The ESD protection devices are the ones just after every USB connector (TI SN75240PWR), except if I am understanding sth completely wrong :) . \$\endgroup\$
    – aletsoup
    Apr 13, 2016 at 14:18

1 Answer 1

1
\$\begingroup\$

You can check the line impedance on many WEB sites, for example: http://www.hughescircuits.com/index.php/en/support/impedance-calculator

However: the impedance matching becomes important when the line length is longer than 5-10% of wavelength. The wavelength on FR4 PCB is 2e8/f (length in m, frequency in Hz).

\$\endgroup\$

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.