0
\$\begingroup\$

I'm trying to configure an ADC (ADC12j4000) and I need to configure the number of serial lanes (denoted as L in the page 39 of the datasheet). For some factors as D, DDR, P54, K... I can see how to configure them in the page 70 of the datasheet, where by some address, I can configure the ADC for the desired values. But as I mentioned before, I am not able to configure the number of lanes. Is there any other way to do it?

Any help is appreciated! Thanks for all!

\$\endgroup\$
1
\$\begingroup\$

You do not configure the number of lanes. This is derived (automatically determined) based on your selections for other parameters.

\$\endgroup\$
  • \$\begingroup\$ Thank you! It was not at all derived by the ADC, but I had to configure it deeper (via AXI), so your comment helped me to watch at other datasheet where I could modify that value. Thanks! @glenn-w9iq \$\endgroup\$ – euskadi Jul 28 '17 at 12:05

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.