# Replace a trimmer potentiometer with a thumbwheel (rotary) potentiometer [closed]

I am trying to make an LED strip dimmer circuit using LM2596 Buck converter, but the trimmer pot makes it difficult to change the brightness every time. Is there any way to replace the trimmer pot with a rotary pot , if so then what wattage and resistance should I keep in mind in buying the appropriate rotary pot ?

## closed as off-topic by Bimpelrekkie, Voltage Spike, Harry Svensson, pipe, winnyNov 20 '17 at 11:13

This question appears to be off-topic. The users who voted to close gave this specific reason:

If this question can be reworded to fit the rules in the help center, please edit the question.

• 1) off topic 2) it depends on how the original potmeter is used (which you do not show, there are many ways to make a dimmer with an LM2596 and a potmeter so include the actual circuit) if it can be replaced with a different potmeter. – Bimpelrekkie Nov 14 '17 at 8:10
• @Bimpelrekkie I suspect it is one of those super-cheap units that includes TWO pots -- one for setting the voltage and one for setting the current limit. The OP doesn't say which of the two they are using to control the brightness. But for these $12\:\textrm{V}$ strips anyway it tends to work okay using either the current control pot or the voltage control pot. (I actually did this with an LED strip using those cheap controllers. So that's why I have a small clue.) – jonk Nov 14 '17 at 8:49
• Those tiny multiturn pots have no power requirement to speak of. Regarding the resistance, just remove the pot and use an Ohmmeter on it. That will tell you what you need for resistance. Power won't be an issue. But if you buy one of those pictured, then it is just one turn and that may be a problem for you as too much change may occur for very minor adjustments. Perhaps you should just consider buying a larger multiturn pot with a knob. Multi-turn pot seller – jonk Nov 14 '17 at 8:56
• Have you discounted the possibilities shown by searching for "trimmer pot knob" and looking at the images? – Andrew Morton Nov 14 '17 at 10:40
• @UditSarkar You can get trimmer pots just like the one you show but they have a grooved shaft to add a knob example, also you can get knobs with a long shaft that you could attach to the existing pot example. Either way would avoid moving the trimpot away from the PCB which could possibly make it unstable or susceptible to noise pickup. – Andrew Morton Nov 14 '17 at 18:40