I currently have a 36vbdc 800w motor connected to a 36v 800w motor speed controller (similar to what they use to control ebikes) just like this one: https://aws.robu.in/wp-content/uploads/2016/02/919811586_739.jpg (I don't know how to upload pics or wiring diagrams to my question or I would).
I would like to use a 2.4ghz 4ch RC remote transmitter and receiver to control the motor speed instead of the wired throttle I currently use, which is a 3pin hall sensor (+5v, Gnd, sensor) twist throttle.
Is there any way to connect the RC receiver to the motor controller to use the remote transmitter to control motor speed? How would I go about this?
I believe both the RC signal and the hall sensor are PWM, but do I need a receiver board to interface with the RC receiver and the motor controller?
Would I need to implement arduino into the equation?