0
\$\begingroup\$

1- Am I correct in my schematic if I want to connect L298N to arduino to drive 2 motors ?

2- are the resistors of 0.5 ohm mandatory ? (I saw them in datasheet)

3- Am I missing components in my scheme ?

Motors consume 24 volt and max current of 300 mA

L298N allow me to change the sense of rotation or motors

Diodes are 1N5819

thank you

schematic

simulate this circuit – Schematic created using CircuitLab

\$\endgroup\$
  • \$\begingroup\$ There are a gazillion images on google how to wire these up - just check there and come back if you see a difference that you can't understand. \$\endgroup\$ – Andy aka Feb 14 '18 at 17:58
  • \$\begingroup\$ hello Andy. I ask that because there is a bunch of different diagrams on google. All of them are different to each other. So thank you for your answer. \$\endgroup\$ – redouane Feb 14 '18 at 18:01
  • \$\begingroup\$ And then we have your circuit (that might be different again) but only you know the design ideas behind it. \$\endgroup\$ – Andy aka Feb 14 '18 at 18:20

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Browse other questions tagged or ask your own question.