0
\$\begingroup\$

When I search for opamp-based voltage to current converters, I find scads of circuits with a transistor driver on the output of an opamp or variations on the Howland circuit.

I'm beginning to doubt my sanity -- it seems like the following would work just fine, as long as the device to be driven doesn't need to reference ground:

schematic

simulate this circuit – Schematic created using CircuitLab

Aside from the lack of ground reference and the other usual opamp caveats (stability in the feedback loop, maximum drive current and voltage), are there any things to watch out for using this configuration?

\$\endgroup\$
  • 1
    \$\begingroup\$ The problem is that you don't specify what the DUT is. Such a configuration, as any other, has its limits, which depend on the nature of the DUT. For example, if the DUT is a capacitor, then you have built an integrator that will saturate if Vin has a nonzero offset (i.e. DC component) and this will force you to add components to discharge it. Please, state clearly the problem you are trying to solve. This would allow us to give you more focused and meaningful answers. \$\endgroup\$ – Lorenzo Donati -- Codidact.org Apr 9 '18 at 7:09
  • \$\begingroup\$ @LorenzoDonati: I think I covered that in that "usual opamp caveats" clause above. The issues you cite (i.e. a saturating integrator) would be true for any voltage to current converter. I'm asking if there are any issues with this particular configuration. \$\endgroup\$ – fearless_fool Apr 9 '18 at 14:04
  • \$\begingroup\$ ...but having said as much, I'm planning on driving an inductor. :) \$\endgroup\$ – fearless_fool Apr 9 '18 at 14:06
0
\$\begingroup\$

Looks good. Just remember that a negative Vin will result in a positive output to P2 in an attempt to keep the op-amp (-) pin the same as the grounded (+) pin.

So a positive voltage into Vin would do just the opposite. Op-amps always try to keep both inputs at the exact same potential, so make sure your 'DUT' can handle voltage in both directions, and its resistance match's 'R' or is not to far from it.

If the DUT has a high resistance the op-amp will have substantial gain-it may saturate to the + or - rail in an attempt to keep the inputs at the same potential.

I do not think you will use more than +/- 15 volts to power the op-amp, so as long as the DUT can tolerate that voltage you are safe to experiment. Keep 'R' above 2K ohms to limit the current into the DUT and within safe levels the op-amp can handle (+/- 5 mA max load).

|improve this answer|||||
\$\endgroup\$
  • \$\begingroup\$ "a positive voltage into Vin would do just the opposite." Heh -- notice I didn't drawn an arrow on the current label -- that was intentional. \$\endgroup\$ – fearless_fool Apr 9 '18 at 14:07
  • \$\begingroup\$ What you have 'drawn' is an inverter with a DUT as a feedback element. DUT can have a linear or LOG response. \$\endgroup\$ – Sparky256 Apr 9 '18 at 20:03

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.