0
\$\begingroup\$

I have a SS49E hall effect sensor. I want to measure magnetic field in gauss using arduino analog output. I have a code for analog application but is this appropriate just for the dc magnetic field measurement? I am using a voltage transformer whose turn ratio is 100 V and 34,5 kV primary and secondary windings respectively. The transformer provide AC current at 50 Hz so there is AC magnetic field in the test setup. Finally, can i measure the AC magnetic field at a constant frequency is 50 Hz with the arduino? Or is there another microconroller for the this measurement?

\$\endgroup\$
  • \$\begingroup\$ You can but do some research at Allegro and use those allegromicro.com/en/Design-Center/Technical-Documents/… \$\endgroup\$ – Sunnyskyguy EE75 Jul 18 '18 at 19:57
  • 1
    \$\begingroup\$ @Fatih: I think you're going to really struggle with this. You can't measure with a microcontroller's output and the Arduino series don't have one anyway, as far as I know. You would need an analog input instead (which they do have). Since the field is alternating at 50 Hz you will have to sample at a much higher rate than that to get meaningful results. You will also need to be able to handle reversal of polarity. \$\endgroup\$ – Transistor Jul 18 '18 at 21:48
  • \$\begingroup\$ Yes you are right, i am wrong but my application include just analog input. I write wrong the question. \$\endgroup\$ – Fatih Atalar Jul 20 '18 at 7:58
0
\$\begingroup\$

As an indicator of field strength the SS49E will be just fine, but if you want to calibrate this as a gauss meter then it may be more problematic. I assume you incorrectly used analog output where you meant analog input in your question.

The SS49E outputs about half supply voltage (you are likely to see 2.5 +/- 0.1 commonly among devices) with zero gauss detected. You will need to provide an offset and gain facility to get any reasonable calibration.

A more suitable (though hard to get at times) linear Hall Effect device would be the WSH315 which has flexible VDD offset adjustment which can be made to track your A/D reference.

\$\endgroup\$
  • \$\begingroup\$ Thanks Jack, I realized i write wrong in the question about analog application. So it is not output but it is a analog input on the board and arduino code. \$\endgroup\$ – Fatih Atalar Jul 20 '18 at 7:57
  • \$\begingroup\$ I calibrated SS49E with a gauss meter. But i can not measure ac magnetic field strength in a gauss level. \$\endgroup\$ – Fatih Atalar Jul 20 '18 at 14:19

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.