I designed an H bridge using the DGD0506A gate drivers. https://www.diodes.com/assets/Datasheets/DGD0506A.pdf
I have tried it with a DC motor and a 5k resistor connected to the load, no chance with either of them. I checked a few volrages and the Vs is sitting at around 9.5v with respect to ground (drops quickly to 7.8 volts when measured by a multimeter or oscilloscope) but the voltage across both tantalum capacitors is 0. I've created this exact same circuit 3 times and I'm running out of them but I've had no luck finding what the problem is. (both EN1 and DIR1 are 3.3v signals,DIR1 is digital High/Low, but EN1 is a PWM @25KHz. VCC is 12v and VDD is not being utilized here but it would be 3.3)
I was wondering if you guys can help me troubleshoot this issue and perhaps get this board working. I have enough parts to make 1 new board but that's pretty much it.Thank you very much.