3
\$\begingroup\$

I recently purchased a small 1 inch OLED screen. In the datasheet, it shows the max power requirements as:

Operation: 3.5v
Logic: 2.6v
IO: 3.5v
Display: 13.5v

I figure I can directly connect the operation and IO pins to the 3.3v power. I guess for the logic pin, I'd use a voltage divider circuit? What about the display? Since it's a small little screen, I don't expect the current to be much of an issue, but how do I boost the voltage from 3.3v to 13v?

Since I'm new, I would normally use a pre-made breakout board, but in this case I'd rather learn how to do it instead.

Edit: The driver is a SSD1351. Here is a link to the datasheet: SSD1351

Edit 2: The datasheet I have for the display is marked as 'Confidential' and doesn't appear available online. I got it sent in email from the manufacturer. So I don't have a link, but I found the current information for the display:

30% of display: 13.3 typical, 17.0 max mA
60% of display: 23.2 typical, 29.0 max mA
100% of display: 33.4 typical, 42.0 max mA

\$\endgroup\$
  • \$\begingroup\$ Do you have any reference, or photo of the module? \$\endgroup\$ – TEMLIB Nov 18 '18 at 1:41
  • 1
    \$\begingroup\$ You need to specify the maximum current requirement at 13.5V. Chances are good that the logic and I/O will operate from your 3.3V and you just need a 13.5V source for the display. Please link datasheet for the display. \$\endgroup\$ – Spehro Pefhany Nov 18 '18 at 3:02
  • \$\begingroup\$ if 13.5 is absolute maximum, changes are good that it will opwerate from 12V, still you'll need a way to boost 3.3 up to 12V for that more details would be good. \$\endgroup\$ – Jasen Nov 18 '18 at 5:13
  • 2
    \$\begingroup\$ It's set by a resistor. You need the datasheet for the display as well as the driver. \$\endgroup\$ – Spehro Pefhany Nov 19 '18 at 2:40
  • 1
    \$\begingroup\$ where do you see 2.6V ? \$\endgroup\$ – vlk Nov 20 '18 at 8:21
1
\$\begingroup\$

Driving OLED displays is easy, but you need to provide two voltages:

  • supply for the digital part of the display is 3.3V from your logic
  • supply for the display drivers is 10V - 18V from any step-up driver (higher voltage means higher brightness and also higher current)

For inspiration of the supply, here is breakout with your display display and also schematic.

\$\endgroup\$
  • \$\begingroup\$ Yes, that's it. It looks like the FAN5331 IC does the work. The datasheet has the same circuit in that schematic. Thanks for that! \$\endgroup\$ – Jason Nov 22 '18 at 1:46

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.