I made a power pack using 18650 batteries from an old laptop. All batteries tested individually are good. 4 batteries in 2S format. I used a cheap 2S 3Amp rated protection board I got on Ebay from China. I correctly connected all the terminals and properly soldered, B+/B- to the +/- of the final ends of battery and BM to the middle.
The voltage measured directly at the battery terminals (at B+/B-) is 8.4 volts but at P+/P- of the board it measures 7.5. Which means this board will not produce more than 7.5 volt usable voltage even when the batteries are fully charged to 8.4. Is that expected and normal? or is there a problem with the board.
Thanks for help.