0
\$\begingroup\$

I'm using ActiveBOM in Altium Designer 19. My design has 100k 5% resistors and also has 100k 1% resistors. ActiveBOM gives an informational warning (an "i" with a white circle around it) that the value 100k is a duplicate. I'd like to clear this error.

I'd guess there's a way to suppress this error in Project Options, but I don't want to do that because finding duplicate parts is a good feature.

I could also change the 'Value' field of one of the parts, but that doesn't seem right because they both actually are 100k.

I guess I could change my use of the resistor value field to include the tolerance, but that seems like it might mess up simulation (which I haven't started using yet).

What's the best way?

\$\endgroup\$
  • 1
    \$\begingroup\$ This doesn't tell you how to clear the error directly but the cost of 1% vs. 5% resistors (well, 100k resistors) is small, and a quick look shows that the 1% parts can actually be cheaper than the 5% parts. \$\endgroup\$ – Peter Smith May 10 '19 at 13:06
  • \$\begingroup\$ @PeterSmith That's a good point, but I have a similar issue in other places where that substitution doesn't make sense: like a 10k resistor and a 10k thermistor, a 5% resistor and a 0.01% resistor, ... \$\endgroup\$ – Casey May 11 '19 at 9:30

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Browse other questions tagged or ask your own question.