I was searching through the internet to find PCI Express card edge connector footprints / technical drawings / pin spacing / layout of the module cards that you stick in these connectors you can find on a modern PC/server motherboard.
I wasn't able to find anything so I thought I could maybe ask here? I found some for Altium Designer which I don't have access to and also I am using (Autodesk) Eagle.
If you are wondering, I wanted to create a PCIe 3.0 x8 card that could hold two M.2 NVME SSDs since I could not find this anywhere either. Everyone only sells the type that holds one NVME (PCIe) and one SATA SSD. This is not what I need.
M.2 NVME interface is basically just a PCIe x4 interface, in another form factor. Therefore I don't see a problem with making a x8 standard card for PCs/servers that could hold two of those and properly route their interfaces.
Can anyone help? Thank you!