0
\$\begingroup\$

I just got a STM32H747I-DISCO board. When I try to debug it and load the code to it by using its internal ST-Link and STM32Cube IDE. It says :

Break at address "0xa05f0000" with no debug information available, or outside of program code.

And when there comes a little option( View Disassembly) that leads me to some assembly code. How can I fix it? I am just trying to make simple led blinking. To be honest I have no idea how to use this board. This is my first time with it, maybe I am trying to write codes to the wrong core? Or maybe the problem is in the debug properties. Also in the debugger console when debugger just started there are those messages:

set *(unsigned int *) 0xE0043000 &= ~0x1 (in red)

Temporary breakpoint 1, main () at ../Core/Src/main.c:148 148 __HAL_RCC_HSEM_CLK_ENABLE();

After resuming the debugger there is this message:

Program received signal SIGTRAP, Trace/breakpoint trap. 0xa05f0000 in ?? ()

How can I fix this thing?

\$\endgroup\$

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Browse other questions tagged or ask your own question.