I have recently purchased a sparkfun protoboard that I wish to stack above an ethernet shield. (I have 2 different ethernet shields, an Arduino one and a seeed studio enc28j60 shield.)
The problem I have is that if I use the supplied headers, or even the longer "Arduino Stackable header" then the magjack from the ethernet shield below contacts the protoboard. This happens before adding the components at the front of the board, I suspect that if I solder those in the header won't even make reliable contact.
So, I'd like to source some extra long headers, either male-male or male-female would be fine. I did notice that the Arduino ethernet shield has extra long headers - does anyone know where to source those or any other 1.5cm long headers from?
It would be awesome if the supplier had a reasonable shipping rate to Australia, but I'll take whatever I can get. :) I have searched farnell without luck so far, but the number of products is a bit bewildering so there is a chance I have overlooked the perfect header.