I have a LED driver with following Push-in screw terminal (from the markings of the side)
Here is the technical drawing. I am unable to figure out the mechanics.
How can I connect the cables?
\$\begingroup\$
\$\endgroup\$
1
-
\$\begingroup\$ You shove the bare wire end into the big bottom hole. You might need to shove a screw driver into the big bottom hole as you do this to hold the spring open. \$\endgroup\$– DKNguyenApr 30, 2021 at 6:43
Add a comment
|
1 Answer
\$\begingroup\$
\$\endgroup\$
1
Figure 1. Wago cage-clamp terminals.
Some of the terminals require a 'just right' screwdriver to release the cage properly. (Some screw terminals require the right tool too.)
Figure 2. Cage clamp and wire showing excellent contact area.
(Photos used previously in my answer to another question.)
answered Apr 30, 2021 at 6:46
-
\$\begingroup\$ Good pictures. With a small screwdrivers I was able to push the clamp in the smaller upper hole forward to reveal the clamp in the bigger hole. Thanks \$\endgroup\$– v3xXApr 30, 2021 at 7:02