1
\$\begingroup\$

Background info: I'm trying to create a spark gap tesla coil that uses a ZVS / flyback combo, and so far, given the initial tests with a 12 volt 20 amp power supply, I managed to get it to work, but when I increase the gap between the spark gap, the sparks went through the secondary coil, which could signify that the primary/secondary is too coupled. Note that the primary coil design I used before I took it down is a vertical type.

So I thought after looking at the designs, I should either go with a flat or pancake coil design for the primary, but which one of the 2 suits them best or should I go back to using the vertical type again? I hope I get much powerful sparks for such a small-medium sized coil!

Here is what my tesla coil looks like, note the stick is supposed to be where the primary coil is supposed to be: enter image description here

\$\endgroup\$
1
  • \$\begingroup\$ There are few Coilers on this site, you won't get knowledgable replies. You'll do better looking for a specialist TC forum like pupman, or High Voltage forum with a specialist TC section like 4HV. \$\endgroup\$
    – Neil_UK
    Aug 4, 2021 at 4:51

1 Answer 1

1
\$\begingroup\$

I believe what you are seeing is the phenomena that the larger the spark gap, the more voltage is needed to jump the gap and or maintain the ARC. They make a crona paint that if you paint the windings with should solve your problem. It has been a long time since I worked with spark gaps and jacob ladders.

\$\endgroup\$
4
  • \$\begingroup\$ Oh, I also lacquered the secondary coil, it's a must when making a spark gap tesla coil. \$\endgroup\$ Aug 4, 2021 at 1:05
  • \$\begingroup\$ From what I gather sparks are going through the lacquer. Just a note your assembly looks very nice. \$\endgroup\$
    – Gil
    Aug 4, 2021 at 1:10
  • \$\begingroup\$ Yeah, It seems to be the case, but it also looks like it's jumping to the primary (it's honestly too quick as I need to unplug it to avoid the damage.) So that's why I wonder if it's the cause of high coupling, so either use the cone or flat coil for primary? PS, thanks for my design! I honestly want to make it more presentable, compact, and easier to fix. \$\endgroup\$ Aug 4, 2021 at 1:14
  • \$\begingroup\$ There was an insulation material we called "fish tape (a yellow insulating tape)" which I believe was actually varnished cambric, a good HV insulation. That was a way long time ago, I am not sure if the terms are correct anymore. \$\endgroup\$
    – Gil
    Aug 4, 2021 at 2:04

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.